Home > Fasteners > BigBond Surface-Mount Adhesives > BigBond FS Acrylic Adhesive >
BigBond FS Acrylic Adhesives |
BigBond FS Acrylic is a very high strength, two-component, methacrylate-based adhesive for use in surface-mounting BigHead fasteners in high-load situations, and in:
- Structural joining of metals, concrete, polycarbonates, GRP and composite constructions
- Ultra-powerful, high-load adhesive for use in building and construction applications
- High-impact applications in ceramics-based products. High viscosity, non-sagging
- High-strength adhesion in cars, coaches, commercial vehicles, aerospace & transport
- General use in Marine, signmaking, retail displays, and external cladding applications
Preparation:For maximum performance use a cleaning agent to clean and degrease the substrate’s surface. For maximum adhesion on non-porous surfaces, remove all paint and other coatings and thoroughly abrade the substrate’s surface before degreasing. FS Acrylic is a high-viscosity, non-sagging adhesive; after application, support is needed for 4-5 minutes for initial bonding. Although initial working strength takes 30-40 minutes, full strength needs a 7 day cure period. |
 |
|
 |
| |
|
|
| The surface (stainless steel shown to take the BigHead must be clean and free of grease, oil, etc. On non-porous surfaces, use a suitable cleaner for maximum adhesion performance. |
|
Spread a generous layer (3-4mm) of adhesive as shown; make sure the amount you apply will cover the whole head area of the BigHead to be fixed, for maximum strength. |
| |
|
|
 |
|
 |
| |
|
|
| The adhseive and hardener are automatically mixed in the special mixer nozzle supplied. When starting a new tube, expel the first 1” or so to ensure a 50/50 mixture is achieved. |
|
Press/rotate the BigHead into the adhesive. Optimum film thickness is 0.5mm - 0.75mm Initial ‘grab’ when applying to vertical surfaces may need support for first 5 minutes’ cure |
|
| |
| PLEASE NOTE: as with all adhesives, FS Acrylic generates maximum strength after a substantial cure time of up to 7 days. However, the product’s very high performance means that its loadbearing ability is excellent after a few hours. We’ll happily discuss customers’ applications, and supply ‘safe’ cure times for specific applied loads |
| |
| We make every effort to ensure that the information provided on this page is accurate, we can not be held responsible for any errors, typography or otherwise. Illustrations are representational of typical styles and designs may vary. Product images should not be used for product specifications. For new applications we recommend that assembly tests are carried out using samples supplied by us. |
| |
Contact the Hall-Fast Sales Office for more information on (01623) 551 791
Email us at: sales@hall-fast.com
Print this page |
|
|
